It's easy:
(1) Remove the stock Airhat and Intake Tube (Or whatever you have)
(2) Disconnect the plug to the IAT Sensor
(3) Install a 1/4" NPT Pipe Plug into the location where the IAT Sensor was
(4) Drill/Cut a 3/8" Hole into the intake tube
(5) Screw (or silicon) the IAT Sensor into the hole (Don't get any
glue/silicon on the tip of the sensor)
(6) Let it dry/tack for about 10 minutes
(7) Reinstall the connector and airhat assembly.
(8) Reset the computer (Disconnect the NEG side of the battery, turn the key
to the START position and hold for about 15 seconds, reconnect the battery.)
(9) Drive for about 30 miles for the computer to learn the new settings.
- Bernd
----- Original Message -----
From: <Rcpilot000@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Friday, December 31, 1999 1:59 PM
Subject: DML: archives for IAS
> Where can I find these archives?
> I would like some more information on this mod.
>
> Thanks
>
> Wes
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:46:24 EDT