>Actually I did use my fingers and hands. I was aware of the tolerance
>problem, so I made sure I sanded as flat as possible, and equally in all
>areas (I didn't spend more time in one area than another, causing a potential
>"low spot") I was especially careful directly around the cylinders where the
>rings will be crushed. I was goinf to use a sanding block, but all I wanted
>to do is sand enough to get the old gasket material off, and was afriad I may
>take off too much material with the sanding block. Hope I did it right.
>
>-Austin
>Vipertruck
Yep, did good.
Mike
__________________________
mschwall@flash.net
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:47:01 EDT