Gee, your buddy couldn't make me a set of wheel spacers out of 1/4" steel plate
with the holes for the studs being only 5/8" opening. These would have to be
the same diameter as where the wheels butt up against on the rotors with the
center hole being 1/8" larger than where the center hub assembly fits through.
I thought I would ask since I tried my local machine shop (really good work)
and they quoted me $250 for 4 !!! I thought that was a little high for a simple
job. I've been looking around but nobody else wants to bother. If not no prob,
but thanks for reading.
Jeff Durling
'96 RC Sport - 318
Jon Steiger wrote:
> On Thu, 10 Feb 2000, Clay Cooke wrote:
>
> >
> > Great page Jon!!! All the info anyone would ever need to put that intake
> > on!!! and the install kits look great!! Who did the machine work on the
> > vaccum tree and the ECT adapter?? Great Great Great!!
>
> Thanks! :-) The machine work was done by a local machine
> shop. The production manager there makes parts for me on occasion
> on his own time. It means it might take a while to get something
> done when the shop is backed up with "official work", but its a
> *lot* cheaper than going through the machine shop itself! (These
> kits probably would cost double or triple what they do if I went
> through the normal process, due to the small quantities.)
>
> -Jon-
>
> .--- jon@dakota-truck.net -- or -- stei0302@cs.fredonia.edu ------------.
> | Jon Steiger * AOPA, DoD, EAA, MP Race Team, NMA, SPA, USUA * RP-SEL |
> | '92 Ram 150 4x4 V8, '96 Dakota V8, '96 Intruder 1400, '96 FireFly 447 |
> `---------------------------- http://www.cs.fredonia.edu/~stei0302/ ---'
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:48:01 EDT