Pardon the lack of knowledge, but what are "pre runner" fenders? Was the dakota you saw
stock with 33's and no lift?
-Mike
-----Original Message-----
From: SS454454@aol.com [mailto:SS454454@aol.com]
Sent: Tuesday, February 15, 2000 1:42 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: Lift?don't think it can be done36's
In a message dated 02/15/2000 2:16:48 AM !!!First Boot!!!, Ohm347@aol.com
writes:
<< you can't fit that on your truck. if you offset it inwards you will rub
the
frame violently. outwards you will rip the fenders and tires to shreads.
petersen's 4wheel & off road could only squeeze a 35 under a ram with out
rubbing after a 5 inch lift(if memory serves me).
the wheel wells on a dakota are smaller than a ram. you will have to trim
the openings to clear a tire of that magnitude and you don't have a lot of
room to maneuver with between the wheel well and the doors. the extreme
dakota everyone was talking about earlier was lifted close to a foot to fit
the 39.5's it runs and they don't enter the wheel wells in the slightest
when
it is sitting level.
sorry man. i want 35's x 9.5 on my 98 but i don't think it can be done
without some custom lift work.
good luck
you are going to need it
derek
>>
I just saw a dakota that had pre runner fenders. i pulled the dude over and
he said it was all stock with 33s no ru=bbing. he said he tried 35s but he
needed a 3 inch lift.
Rob
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:48:07 EDT