RE: cams

From: Steve St.Laurent (saint1958@home.com)
Date: Fri Feb 25 2000 - 09:24:48 EST


I would go with 10.0:1 ratio versus 9.0:1. More horsepower yet run 92 or
less on the Octane gas.

-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of mike d.
Sent: Thursday, February 24, 2000 9:48 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: cams

>>What rear end gears, what size tires? What do you want to do with
it? Where do you want the most power? Up high in the RPMs, or down
low? Plan to tow, race, or all around increased power? Any mods to the
intake or heads? What was done to the engine by the mechanic<<

um.. uuuuh... I DIDN'T DO IT!!! =)

rear: 3.92
tires: 275/60R15's BFG Drag radials
plans: more power throughout rev range/Run 13's
intake and heads are stock
Forged pistons and rebuilt motor... maybe up the CR, but I don't know
what my options are for that... probably gonna stick with 9:1, but maybe
9.5:1 will gimme alittle extra ponypower....

-mike d.

---> Yorktown, Va.
"PROJECT 13's" .... 88 Dakota LE: slammed, painted, and gettin' a built
Magnum 360

miggitymike@juno.com
http://members.xoom.com/dakotaperf/index.html

________________________________________________________________
YOU'RE PAYING TOO MUCH FOR THE INTERNET!
Juno now offers FREE Internet Access!
Try it today - there's no risk! For your FREE software, visit:
http://dl.www.juno.com/get/tagj.



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:48:47 EDT