At 08:58 PM 2/29/2000 , you wrote:
>True enough!! and good point!!!!
>
>but according to (I think this is wear I read it) Kammer and Kammer the
>total valve lift a magnum engine can handle is .512 (or maybe .518) and
>with the 1.7s Ill be right at .5, so I should be safe. I think that .2"
>seems a little big cuase if your stretch steel .2" it wont go back, so you
>would be out side the elastic limit. So it has to be less.
>
>Clay
Yeah I agree. .200" is too much. I'll see if I can look it up. I have it
either in my many word documents (over 5 MB of nothing but engine data), or
in my data books that are sitting in storage back in San Antonio. Email me
if you find it.
Mike
__________________________
mschwall@flash.net
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:49:30 EDT