ok, now THAT is how me and my brother USED to do it on the "old" cars we had
:) Did NOT know if I can do the same now seein as how I have something that
is post 70's models ;)
Heather
----Original Message Follows----
From: DRD892@aol.com
Reply-To: dakota-truck@buffnet.net
To: dakota-truck@buffnet.net
Subject: DML: Engine Cleaning, Attn: Heather
Date: Fri, 7 Apr 2000 13:55:28 EDT
Afternoon Heather,
This is how I have kept my '97 5.2 clean for 3 years.
Take it to a Quarter CarWash (which isn't a quater any more).
Use the Rinse cycle at low power and get the engine bay
completely wet. Then spray Simple Green generously in
the entire bay. Immediately rinse off. I use the high pressure
Rinse but you can use the low pressure also.
The only thing I cover is the K&N Filter. I have never hand a problem
with the computer or distributor although you must have good wires
that seal. (I use ACCELL 8mm).
I just uncover the K&N and run the engine. The whole engine bay looks
brand new.
Good Luck.
David R.
Sterling Heights
Michigan
drd892@aol.com
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:50:38 EDT