That's the basic idea behind the MSD and Jacob's ignitino boxes, you can
remove the fuse (basically cuts power after the coil, since the jacobs uses a
magnetic pickup unit) anyways. It wouldn't be that hard to wire a little
push button kill switch for the coil.. snip snip, run a few wires adn you're
set.
-Dester
<< Actually,I`ve tossed this idea around myself.The 12 volts going to the
ignition coil should be low current (should be able to use a small
switch to break that),and mount it in the glovebox.Use a push-on
push-off switch,mount it like a trunk open switch in a car.Who would
check the glovebox if they can`t get the truck started? Also,it wouldn`t
take a lot of wire because the glovebox is pretty close to the ignition
coil.My preference would be a black switch for camouflage.(camoflage?)SO
YOU CAN`T SEE IT.That I can spell.
>>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:12 EDT