Kyle, before you put the TB on, place the gasket squarely on the TB. Mark
and trim any excess that may fall in the way of the bores. Place the TB and
gasket on the manifold, loosely install the bolts, and open the TB plates.
Look through the bores, and make sure the gasket isn't sticking in the
air-flow path. If it is, even it up with your fingers, then tighten down
the bolts. All said and done it should take you about 10min to swap the TB
out
Jon Smith
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:12 EDT