At 10:00 PM 5/13/00 -0400, you wrote:
>1)Has anyone opened up a computer out of a late model Dak and looked at
>the circuit board? (Gen III Dak)
No. See 2) below.
2)Do they epoxy the board, or is the solder side accessible?
Epoxied.
>3)Is there only one computer to control engine and transmission,or is
>there a separate module for each?
One.
4)Where are they/is it located?
On the passenger-side inner fender wall.
Bob. Ont, Canada. '97 Dakota CC, 5.2L, 4x2, 3.92 SG, auto., 4350 lb.
RWHP: 226.2 (corrected) 231.2 (measured)
RWTQ: 332.5 (corrected) 340.0 (measured)
PB: 14.857 @ 91.67
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:18 EDT