JOn,
You need to take it in to the dealer to have it set with the analyzer. I
spoke to them about two weeks ago on this. They told me that even if you
put everything back exactly where you had it, it will probably be off.
I have mine set dead on the adjustments and it runs ok, but I am sitll going
to take it in and let them set it.
Rich - Ashburn, VA
-----Original Message-----
From: Jon Smith [mailto:fast4x4@bellsouth.net]
Sent: Sunday, May 14, 2000 9:16 PM
To: DML
Subject: DML: dist. out of whack?
Ok, I think I may have licked this leack problem.. I replaced the
distributor O-ring today.. got everything put back together, but the truck
idles high, then just about stalls out, then just plain erradic... Sounds
very similar to a crossed plug wire, but that's not the case. I made sure
to mark the position of the distributor and it's aweful close to how it came
out.. How sensitive is the distributor in that respect? Any other ideas
what could cause it to run this poorly?
___________________
Jon Smith--Raleigh, NC
95 CC 318 4x4 auto
15.4@89.5mph
fast4x4@bellsouth.net
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:18 EDT