OK...this is just too wierd.
Several people on the DML have posted just about the exact thing as well as
two people at my work as well.
What the hell is this??
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Heather M
Sent: Tuesday, May 16, 2000 12:05 AM
To: dakota-truck@buffnet.net
Subject: Re: DML: RE: Rough Cold Idle/Coolant Sensor
My little baby 4cyl has this problem...whenever I start it in the
morning...it kinda hesitates staying at a high enough idle to not choke and
kill the engine. :( I changed the plugs thinking they were dirty and not
connecting and nada...used a fuel injector treatment and nada...now what?
Heather
----Original Message Follows----
From: "Wisotzkey, Rich" <Rich.Wisotzkey@gd-wts.com>
Reply-To: dakota-truck@buffnet.net
To: "'dakota-truck@buffnet.net'" <dakota-truck@buffnet.net>
Subject: DML: RE: Rough Cold Idle/Coolant Sensor
Date: Mon, 15 May 2000 12:13:29 -0400
Kyle,
Before spending any money on sensors, take off the TB and clean it. Make
sure you clean the IAT sensor and where it seats. Let me know how it runs
afterward.
Rich - Ashburn, VA
-----Original Message-----
From: Kyle Kozubal [mailto:grndak4x4@home.com]
Sent: Monday, May 15, 2000 10:57 AM
To: dakota-truck@buffnet.net
Subject: DML: Rough Cold Idle/Coolant Sensor
First, what could/would cause my truck to run rough, only on cold start-ups?
Once the truck warms up and is started things are fine, and it doesn't idle
like I have a 440 under the hood with a wild & nasty cam stuck in it. My
truck has done this for a while now, and even though it doesn't bother be
'that' much, I still would like to fix it. I am leaning towards the coolant
sensor, which is about $15 or so.
Has anyone ever replaced this coolant sensor on their Dakota? My
understanding is that there are 2 types:
*One is located close to the thermostat on the manifold which sends the
computer how warm/cold/hot the coolant actually is. Could false readings or
a bad sensor could cause a rough idle at start ups(both cold and warm
startups)?
*The other is used for the temp gauge on the dash. This would obviously
cause a poor or inaccurate reading on the temp gauge on the dash. Where is
this one located?
I have read alot online concerning the coolant sensor and have found a bad
coolant sensor has the potential to cause excessive fuel consumption, poor
cold idle, and even stalling. Like I stated in the beginning, the cold start
ups are nasty and rough, and there are NO fault codes coming up when I do
the key on/off cycle. Oxygen sensor was replaced about 23,000 miles ago; the
cold idle problem did not change and was present beforehand. Any ideas?
Kyle
93 Dakota 4x4 V6
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:19 EDT