WOOHOO!!
I spoke with "Tri" at XS-Engineering and they will send the wiring
schematics via US Mail.
All I need is the wiring diagram for a 1997 Dodge Dakota V6. If anyone has
a FSM, please email me offline. I need the ECU Pinout Diagram.
Thanks,
- Bernd
----- Original Message -----
From: "Bernd D. Ratsch" <bernd@texas.net>
To: <dakota-truck@buffnet.net>
Sent: Tuesday, May 30, 2000 1:40 PM
Subject: DML: Apex-i Fuel and Timing Computer
>
> Just got off the phone with a few techs at Apexi
(http://www.apexi-usa.com)
> and they stated that the Super AFC (Air/Fuel Computer) will work on the
> Dodge OBD-II systems. However, they don't have the time to do a install
and
> they're located in SoCal (Irvine). They did recommended XS-Engineering in
> Fullerton, CA (714-992-4133) for the install but that's a little bit too
far
> for me to drive.
>
> Can anyone in SoCal check into this for me? Mainly...physically
contacting
> XS-Engineering and see if they can do an install on one of our Daks and
> then, possibly, write down the wiring instructions.
>
> Thanks,
>
> - Bernd
>
> Email me privately unless you want to discuss this on the DML.
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:51:28 EDT