In a message dated 7/6/00 7:53:57 PM Eastern Daylight Time,
grndak4x4@home.com writes:
<< Could you look up to see the specifics concerning the NP231 transfer
case and what are the steps or information given about adjusting the
transfer case linkage?? THANKS SO MUCH!! >>
1. Shift transfer case into 4H position
2.Remove shift bezel screws and slide boot, bracket and bezel upward for
access to shift lever and gate (fig. 5 )
3. Secure shift lever in 4H position in the shift gate. Use wire or tape to
hold lever in position.
4. Raise vehicle.
5. Remove adjusting swivel lock bolt and lock plate.
6. Disconnect adjusting swivel from shift arm.
7. Verify that transfer case range lever is in 4H detent.
8. adjust swivel position on shift rod to obtain free fit in the shift arm.
9. Insert swivel in shift arm and install swivel lock plate and lock bolt.
Tighten lock bolt to 90 inch pounds torque.
10. lower vehicle.
11. remove items holding shift lever and install boot, bracket and bezel.
Hope this helps
Bill
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:52:33 EDT