(Only for Dodge motors). ;)
----- Original Message -----
From: "Looper" <davidalooper@yahoo.com>
To: <dakota-truck@buffnet.net>
Sent: Thursday, July 20, 2000 12:51 PM
Subject: Re: DML: Re: RE: Re: I want a cam
> Hay you left out the ping man. Get it straight.
>
> --- "Bernd D. Ratsch" <bernd@texas.net> wrote:
> > Hehehehe....
> >
> > Suck, Squeeze, Bang, Blow. (4-Stroke Cycle, nothing
> > kinky)
> >
> > - Bernd
> >
> > ----- Original Message -----
> > From: "Wisotzkey, Rich" <Rich.Wisotzkey@gd-wts.com>
> > To: <dakota-truck@buffnet.net>
> > Sent: Thursday, July 20, 2000 12:11 PM
> > Subject: DML: RE: Re: I want a cam
> >
> >
> > > Ditto! You should degree any cam you install. As
> > far as associated
> > > componentry? You could just do the cam and it
> > would be fine, but if you
> > > want to better utilize a cams potential, I would
> > also consider some
> > throttle
> > > body/intake and exhaust work. Remember what your
> > engine basically is; a
> > big
> > > air pump.
> > > Rich - Ashburn, VA
> > >
> >
> >
>
>
> __________________________________________________
> Do You Yahoo!?
> Get Yahoo! Mail - Free email you can access from anywhere!
> http://mail.yahoo.com/
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:52:43 EDT