Ditto ditto ditto
Ron
00 SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Terry Herrin
Sent: Thursday, September 07, 2000 7:39 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Going to MSd ignition-which coil?
David Axmann <bckpack@earthlink.net> wrote:
>I'm getting ready to upgrade to the MSD 6A. I know that lots of DMLers
>use the Accel super coil. I know that this is pretty much an oem,
>epoxy filled, coil. My question is, is anybody using an MSD or other
>coil? Everybody touts the universal harness as it allows easy changing
I'm running an MSD Blaster SS coil with the MSD 6A ignition.
>back to the stock ignition but I would also like to keep the stock coil
>if I wanted to switch back for any problems. I'm not against using the
>Accel as my coil, I'd just mount it in another spot. All things
>considered, is one coil better than another?
I don't know, but I'm very satisfied with the 6A and Blaster SS
combination. You can see on my web page how I mounted both, and there
is a dyno sheet showing the 10hp gain over stock at 3500rpm. I can
switch from MSD back to stock in less than a minute.
Terry Herrin
99 FR CC RT
14.769 @ 91.43
Wilmington, NC
Dakota R/T Club,Executive Board,SE Region
http://users.isaac.net/therrin/dakota.html
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:29 EDT