(1) Disconnect NEG Battery Terminal
(2) Turn key to the START position and hold for 15 seconds
(3) Release Key
(4) Reconnect the NEG Battery Terminal
(5) Start Engine and let idle for about 1 minute
(6) Drive vehicle for 35-50 miles to allow the computer to "Relearn" any new
modifications
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of jay & dana
Sent: Tuesday, September 12, 2000 6:35 PM
To: DML
Subject: DML: resetting computers?
I was wondering if anybody could tell me when you should "reset " the
computer, whether stock or HP? Should it be done after modifications such
as new air intake system, plugs, wires, coil, exhaust etc.?
Hey, the only way to learn is to ask those who know !
Thanks
Jay Friedrich
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:32 EDT