Headers are on !

From: Ramsport96@aol.com
Date: Thu Sep 14 2000 - 23:12:52 EDT


Well i'd like to call them an "exact fit" but i'd be lyin....
Summit and Flowtech said the same too..anywayz..i wound up heating and
bending the #7 tube and may bend the #8 tube later..
i needed clearance on the master cylinder and the a/c evaporator.
as far as performance, the puter is still learning but it sure pulls a lot
harder..and i am using way less throttle..:)



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:35 EDT