In a message dated 9/15/2000 10:05:52 PM Pacific Daylight Time,
Rich.Wisotzkey@gd-wts.com writes:
<< Go buy yourself a couple new
pushrods. Better yet, buy a set of .080" (heavier walled) pushrods. Then
you won't have to worry about bending them again.
Rich - Ashburn, VA >>
No Rich thats not it..I'm taking 1.7 roller rockers and heavy pushrods
out and putting the stock ones back in..The rollers are adj. to 0 cleareance
so the lifter is fully extended (Gets you higher rpm's before valve float
per Kammer & Kammer)..Now this lifter is stuck in the extended position so it
bottoms out the valve spring and bends the stock rod...
Thanks, Ted O.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:36 EDT