Greg, stop by a local dealer with a tape measure :-)
_______________________
Jon Smith--Raleigh, NC
jon@fast4x4.net
www.fast4x4.net
----- Original Message -----
From: <NVMYDakota@aol.com>
To: <dakota-truck@buffnet.net>
Sent: Sunday, September 17, 2000 8:34 PM
Subject: Re: DML: Re: Re: Gen III Durango axle to a Gen II Dakota
> In a message dated 9/17/00 4:44:20 PM Mountain Daylight Time,
jon@fast4x4.net
> writes:
>
> > Greg, there is a DC axle plant guru on the list. I asked him the same
> > question, and unless my memory is fumed from all the brake cleaner i
just
> > got ahold of today, the axle will not bolt directly in.
> > _______________________
>
>
> OK Mr. Guru, whoever you are...
>
> I know the U joints are different, but I allready found a u joint that'll
fit
> my driveshaftm and the larger yoke on the 9.25, BUT I dunno about width
(or
> spring perches) ect...
>
> Greg
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:37 EDT