No they're not "pregapped" at .040". I've run several batches on my truck
and check them all...most are in-between .038" and .042". ALWAYS check them
to be sure.
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Stlaurent Mr Steven
Sent: Monday, September 18, 2000 6:19 PM
To: 'dakota-truck@buffnet.net'
Subject: DML: RE: BW Distributor Cap and Rotor
Why .045 gap when the Autolite are pregapped at .040?
-------------------------------------------
Steven St.Laurent
Test Engineer
Test Branch, GSD, MCTSSA
MARCORSYSCOM, USMC
760-725-2506 (DSN 365-2506)
Work:mailto:stlaurents@mctssa.usmc.mil
Home:mailto:saint1958@home.com
-----Original Message-----
From: Ronald Wong [mailto:ron-wong@home.com]
Sent: Monday, September 18, 2000 4:11 PM
To: DML
Subject: DML: BW Distributor Cap and Rotor
Before I go and take everything out to install I want to make sure I have
the right parts. For the 2000 Dak 5.9 (I don't know if anything is
different in 2000 vs 99 etc.) has anyone changed their cap & rotor already?
Did you replace with a BW C274 and D223 respectively? If not, what did you
use? I will change plugs as well, going to Autolite 3923's gapped at .045
to begin with and see how she runs. MSD has already been installed.
TIA,
Ron
00 SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:39 EDT