Bob,
I have my MTX Thunder-5400 amp under my driver's side seat. I don't have power seats, but I still
had to raise the seat. I used 3/4" particle board. I cut slits in the carpet and slid them under
where the seat brackets go. It's been that way for two years and no problems. I have full motion of my
seat also. You may want to check out the new pre-amped thunder forms. That might eliminate one amp for your subs.
You can get away with a smaller amp that might fit without any adjustments for the rest of your speakers.
-Mike Brown
Pasadena, MD.
97-Dakota Club Cab,5.2L, 4X4, 7" Lift, 35"x12.50" BFG A/T.
http://www.geocities.com/mbrowwwn/index.html
-----Original Message-----
From: bob [mailto:bnich@bellatlantic.net]
Sent: Wednesday, September 20, 2000 9:34 PM
To: dakota-truck@buffnet.net
Subject: Re: DML: Thunderform Amp Mounting (Robert)
Robert Meredith wrote:
> For those of you who are running a MTX thunderform, where have you mounted
> your amp(s)? Got any pics?
Robert,
I have amps under both of the seats and in the CC Door Panel.
If you have a power driver seat you'll have to mount a piece of masonite to
the crossbars...the the amp on top of it. Your seat will still move up and
down but travel will be limited. I have mine adjusted were I like it and have
pulled the breaker so some nervous and jerky bastard who likes to flip
switches a hundred times doesn,t overtravel the seat on me. I also taped a
sign saying "do not replace power seat breaker or try to move
seat...electronic equipment under seat. So if I should take it in to the
dealer he doesn't do me any favors.My amps are listed below.
Regards,
Bob
Lowered 1998 Metalic Red Extended Cab
Western Chassis 2/4" Drop, Gibson Cat Back, Lund Roll Pan, Lund Wiper Cowl
S/S Sport Mirrors, Sport Masters Burgandy Tonnue, Home Grown K+N, F+B TB,
Stillen Bumper Cover, Sony CDX-7850, Three sets of Infinity Kappa's,
MTX 275x's, MTX Thunderform with 10" 7000's and a MTX 2130
Visit my Dak at http://www.geocities.com/motorcity/factory/7995
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:42 EDT