Bernd~
do the shields actually serve a real purpose besides being a pain in the
rear?
~Josh
00 CC V6
>
>Once you remove them, why put them back in?
>
>- Bernd
>
> > I've made it easier to remove the plug heat shieds.
> > First use a plyiers to make the gap in them smaller -
> > the key is to keep them round. Then add a little
> > antiseize compound on the outside. This will make
> > them easier to remove in the future.
> >
> > --- Jon Smith <jon@fast4x4.net> wrote:
> > > yessir, remove the wire (and not the plug) grab
> > > ahold with a pair of
> > > channel-locks and give a good twist-n-pull
> > > _______________________
> > > Jon Smith--Raleigh, NC
> > > jon@fast4x4.net
> > > www.fast4x4.net
> > >
> > > > Thanks for the advice guys. What would be the
> > > best way to remove those
> > > > round plug wire heat shields for the exhaust
> > > manifold? Remove plugs wires
> > > > and pull them out (if possible) with pliers or ???
> > > >
> > > > Thanks
> > > > Jay
> > > >
> > > >
> > > >
> > > >
> > >
> >
> >
>
>
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Share information about yourself, create your own public profile at
http://profiles.msn.com.
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:54:42 EDT