Re: Re: Dyno Pull

From: Jon Smith (jon@fast4x4.net)
Date: Sun Nov 19 2000 - 21:10:40 EST

Next message: Bernd D. Ratsch: "RE: RE: 5spd tranny fluid change"
Previous message: Jon Smith: "318/360 PCM's"
In reply to: John Neff: "Re: Dyno Pull"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

I didn't loose any to speak of. Depends on how much porting and what cam...
I went w/ the Crane 2030 and love it, in fact I wish I had a little more cam
in it...
_______________________
   Jon Smith--Raleigh, NC
        jon@fast4x4.net
       www.fast4x4.net
'95 Dakota 4x4 318 CC auto

Do you think I would be OK if I were to just install the MPI manifold and
one of Hughes torque cams? I don't want to lose any bottom end here.

John

>Ported heads and cam... still running stock fuel system (should be a
>different story by week's end)

Next message: Bernd D. Ratsch: "RE: RE: 5spd tranny fluid change"
Previous message: Jon Smith: "318/360 PCM's"
In reply to: John Neff: "Re: Dyno Pull"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:57:30 EDT