Ok, start it off Bernd.....here come the beer flames!!!!!!!! ;-D
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Bernd D. Ratsch
Sent: Wednesday, December 20, 2000 7:36 PM
To: dakota-truck@buffnet.net
Subject: DML: RE: Re: RE: RE: Correct way to adjust 1.7 roller rockers
Only Germans can handle that stuff...right Rich? GOOD STUFF!!
- Bernd
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net]On Behalf Of Jon Smith
Sent: Wednesday, December 20, 2000 8:58 PM
To: dakota-truck@buffnet.net
Subject: DML: Re: RE: RE: Correct way to adjust 1.7 roller rockers
you drink that Heifer crap!!?!?!?!?? blech!! :-) actually the intake is
usually a case and a 1/5 of 100 proof SoCo =)
Jon "Have tools, will travel" Smith
> Hey Jon,
> I think you are really on to something here. 1 case for rockers, 2 cases
> for an intake, 3 cases for a cam, etc. I like it! Make mine
Hefe-Weizen!!!
> Rich - Ashburn, VA
>
> -----Original Message-----
> From: Jon Smith [mailto:jon@fast4x4.net]
> Sent: Wednesday, December 20, 2000 5:58 PM
> To: dakota-truck@buffnet.net
> Subject: DML: RE: Correct way to adjust 1.7 roller rockers
>
>
> Todd, you put the rockers in your floorboard, hop on I-40 eastbound to
Exit
> 28something, turn right, then go a mile, turn right, 1st left, then a
right,
> then 3rd left and knock on the door that says 1126.... a case of beer
will
> expidite install :-)
>
> ______________________
> Jon Smith--Raleigh, NC
> www.fast4x4.net
> jon@fast4x4.net
> ŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻŻ
>
>
> -
> -I don't remember from the last time we had this discussion but way is the
> -correct way to adjust a set of 1.7 roller rockers.
> -
> -Thanks, Todd
> -Mustang@netunlimited.net
> -www.netunlimited.net/~mustang/
> -
> -
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:05 EDT