Kyle
The K&N breather part #62-1520 that you have on your truck, does it fit into
the original valve cover grommet, or does a new one come with it?
Thanks
Jay
>I used to have a hose going from the driver's side valve cover, which ran
>into my trucks stock air filter housing. When I fabbed up my 'PoBoy'
>Homebrew cold air intake kit, I didnt use this hose going from the air hat
>to the valve cover. I am using a GenIII air hat, probably the air hat like
>you have on your 98 Dak; if you notice there is a little fitting molded
into
>the air hat, which I assume would be for a valve cover breather hose. I
>plugged this hose fitting with a cap and bought a K&N breather. This K&N
>breather is the all metal unit, which I would only suggest buying the all
>metal unit cause the K&N breather with the rubber base will eventually
>dry/heat rot over time and fall apart. The K&N breather I am using is all
>metal and is the 'shielded' version; K&N Breather Filter PN#62-1520. I
think
>I paid somewhere around $20-$25 for it through Summit. Even though it is
>chrome(I dont prefer chrome anything), it looks good under the hood. I
think
>you live close to me(Hammond, IN here), so if you wanna meet up and take a
>look and a trial fit of the breather, let me know. Hope this helps.
>Kyle
>93 Dakota 4x4 V6
>K&N Breather Filter(PN#62-1520; All Metal
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 11:58:42 EDT