Re: Re: Trying to figure out why it's not running like it should...

From: Andy Levy (andylevy@bigfoot.com)
Date: Wed Mar 21 2001 - 18:48:41 EST


FSMs are $90.

TJ Goettner wrote:
>
> How much was that manual that you bought from dodge??
>
> TJ
> ----- Original Message -----
> From: "Tom Slick North" <prodog@swbell.net>
> To: "DML" <dakota-truck@buffnet.net>
> Sent: Tuesday, March 20, 2001 8:57 PM
> Subject: DML: Trying to figure out why it's not running like it should...
>
> > Well, I finally got the chance to start doing a little checking and
> testing
> > on the Dakota today...
> >
> > Performed a fuel pressure check - 45psi... no prob there...
> >
> > I just got in my Factory service manual in earlier this week; money well
> > spent, already!
> >
> > I'm taking the Dak over to a dealer tomorrow, and make sure that the
> > distributor was indexed properly...as I found that if it isn't, that the
> > camshaft sensor will be off and that it helps control the fuel
> injectors...
> > I'm going to also have them check all the sensors, and check the A/F ratio
> > to see if it is running lean...
> >
> > In tranny news on my Dak, I found that the trans pan has a small leak...
> > going to replace the pan gasket as soon as I get the chance...
> > plus, I got outbid at the last minute on a shift kit for it, too... damn
> > last minute bidders!!!
> >
> > Anyway, I'll keep you all posted...
> >
> > Later,
> > Tom "Slick"
> >
> > My Homepage -
> > http://home.swbell.net/prodog
> > Dakota Profile -
> > http://www.twistedbits.net/WWWProfile/dakota/EzewC1MzHo2lA/
> >



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:00:20 EDT