Hey Andrew!
I second Rich's post. The diff cover fill hole is designed "in vehicle
position" which is of course level ground.
Sean
'92 RC Sport 3.9L 5spd - 250,000mi!
'01 CC SLT+ 4.7L 5spd 3.92 LSD Mobil-1!
-----Original Message-----
From: Wisotzkey, Rich [mailto:Rich.Wisotzkey@gd-wts.com]
Sent: Tuesday, April 17, 2001 10:42 AM
To: 'dakota-truck@buffnet.net'
Subject: DML: RE: Manual tranny fluid check????
Andrew,
Just park the truck on level ground. Don't try to level the transmission.
The reference is to the vehicle.
Rich - Ashburn, VA
-----Original Message-----
From: Aajaynefour@cs.com [mailto:Aajaynefour@cs.com]
Sent: Monday, April 16, 2001 6:00 PM
To: dakota-truck@buffnet.net
Subject: DML: Manual tranny fluid check????
The FSM says that the transmission has to be level. I am assuming that,
because the transmission itself sits at a slight angle (down towards the
rear) in
the vehicle that it is not good enough to just park the truck on level
ground??????? Should I jack the back of the vehicle up to level the
transmission? How to tell if the transmission is level? Eyeballing good
enough?
Thanks
Andrew
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:04 EDT