When it comes to impact wrenches they vary in power from 10 lbs to 1000
lbs. I would not recomend using one rated at 400lbs, but if you can get
one rated at 75-100 lbs and turn the air flow down you can safely remove
them. The trick is to ease them out with short bursts of the trigger, if
they initally do not break loose ad some more air pressure (lbs of power)
till they do and release the trigger, then ease them out. DO NOT put them
back in with an impact wrench. Apply anti-seize compound, and tighten them
using a touque wrench to factory/manufactures recommended specs.
Barry Lawton
99 CC DFG 3.9
K&N Air Modified
Stage II Jet
180 degree thermostat
275-60-15's
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:07 EDT