I think it was $75 for two pulls. Could have been only one pull.
Boog
----- Original Message -----
From: "Andy Levy" <andylevy@bigfoot.com>
To: <dakota-truck-moderator@bent.twistedbits.net>; <Y2KDakuda@aol.com>
Sent: Thursday, May 03, 2001 4:23 PM
Subject: Re: DML: Dyno @ Carlisle WAS: Post from Matt Barret about Bruce's
TB
> Dyno at Carlisle? What's the cost, usually? By that weekend I should
> have enough goodies on the truck to warrant a dyno pull.
>
> Y2KDakuda@aol.com wrote:
> > I nice piece of engineering work, that I'd highly recommend. I'll have
it
> > on the dyno in July, at the Chrysler National @ Carlisle PA.
> >
> > Thanks Bruce ! you da Man !
> >
> > Matt Y2K-HEMI
> > '00 RC 4.7L 5 spd 3.92
> > 14.23 @ 94.49
>
> --
> -andy
> http://home.twcny.rr.com/andylevy/ --- andylevy@bigfoot.com
> ----------------------------------------------------------------
> Remember, amateurs built the ark. Professionals built the Titanic.
> ----------------------------------------------------------------
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:25 EDT