RE: Re: RE: Re: RE: Crane roller rockers

From: Wisotzkey, Rich (Rich.Wisotzkey@gd-wts.com)
Date: Sun May 06 2001 - 12:02:50 EDT


Kevin,
You don't need new gaskets if they are the rubber type. They are reusable
and do not leak. Just clean them good before reinstalling.
Rich

-----Original Message-----
From: Kevin [mailto:ksmith@korea.com]
Sent: Saturday, May 05, 2001 6:18 PM
To: dakota-truck@buffnet.net
Subject: DML: Re: RE: Re: RE: Crane roller rockers

Thanks for all the advice with the rockers. I ordered the 1.7's yesterday.
Do Dak's have re-usable valve cover gaskets, or do I need to get new ones?
THIS should be the last question.
----- Original Message -----
From: "Wisotzkey, Rich" <Rich.Wisotzkey@gd-wts.com>
To: <dakota-truck@buffnet.net>
Sent: Saturday, May 05, 2001 1:14 AM
Subject: DML: RE: Re: RE: Crane roller rockers

> Hi Kevin,
> I changed both. The geometry is slightly different from the stock setup.
> The pushrods for the roller rockers are .070" shorter than the stock
length.
> I did a little checking, and it appeared you could probably get away with
> using the stock length pushrods. But the pushrods that come with the
roller
> set are Chromemoly steel. Much stronger than the stock ones.
>
> The Crane part number for the "Energizer" rocker set is 11746-16. Same
set
> from Mopar is P5249800. Hope this helps. Let me know if you have any
other
> questions.
> Rich
>
> -----Original Message-----
> From: Kevin [mailto:ksmith@korea.com]
> Sent: Friday, May 04, 2001 9:44 AM
> To: dakota-truck@buffnet.net
> Subject: DML: Re: RE: Crane roller rockers
>
>
> Rich did you change push rods or keep the stock rods?
> ----- Original Message -----
> From: "Wisotzkey, Rich" <Rich.Wisotzkey@gd-wts.com>
> To: <dakota-truck@buffnet.net>
> Sent: Friday, May 04, 2001 9:38 PM
> Subject: DML: RE: Crane roller rockers
>
>
> > Kevin,
> > Yeah, I've been using them. They work nice, no complaints. I just
> recently
> > found out the Mopar roller rockers are Crane roller rockers.
> > Rich - Ashburn, VA
> >
> > -----Original Message-----
> > From: Kevin [mailto:ksmith@korea.com]
> > Sent: Thursday, May 03, 2001 7:02 PM
> > To: dakota-truck@buffnet.net
> > Subject: DML: Crane roller rockers
> >
> >
> > Anybody running either the 1.6 or 1.7 ratio Crane roller rockers on
their
> > magnum engines? Any problems with installation? Thanks for any info
> >
>



This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:26 EDT