Sender location

From: Kevin (ksmith@korea.com)
Date: Wed May 30 2001 - 03:42:08 EDT

Next message: Alek Benedict: "RE: Removing Decals"
Previous message: Thumper: "Re: Removing Decals"
Next in thread: Mark Kuzia: "Re: Sender location"
Reply: Mark Kuzia: "Re: Sender location"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

I am getting ready to install new electric water temp, and oil pressure
gages. I was wondering if anyone has done this and where they installed
their sending units. In the stock locations, or another location in manifold
or block?

Next message: Alek Benedict: "RE: Removing Decals"
Previous message: Thumper: "Re: Removing Decals"
Next in thread: Mark Kuzia: "Re: Sender location"
Reply: Mark Kuzia: "Re: Sender location"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:01:35 EDT