The K&N Gen-II Intake is about the best out there (Mopar Cold Air is a
K&N with the Mopar label on it). On the plug wires, Any reputable wires
will work much better than stock: Taylor, MSD, Jacobs, JBA, Magnecore,
and Accel are among the higher quality brands. The factory replacement
spark plugs for a '99 R/T are the Champion RC12LC4. The Autolite 5224's
are a direct replacement but still have had much better results with the
Autolite 3923's.
Ok, so I'm a bit partial to the IAT Adjuster...i'll let others report on
their findings (good or bad).
Bernd D. Ratsch
Owner - SpeedTweaks, LLC
http://www.speedtweaks.net
-----Original Message-----
From: owner-dakota-truck@buffnet.net
[mailto:owner-dakota-truck@buffnet.net] On Behalf Of WPG
Sent: Friday, September 14, 2001 9:09 PM
To: dakota-truck@buffnet.net
Subject: DML: Performance Upgrade Help
I know all of this has been covered and is in archives but searching
archives with slow internet sucks. Please help.
FIPK, Mopar, K&N, AIRAID, or other?
Plug Wires, what brand and type?
IAT adjuster, Did it help with pinging on your trucks?
I have the Autolite plugs in my truck. I have it in at a Dodge dealer to
have some service work done. One problem is a stumble leaving lights if
driving easy. They suggested removing the Autolite stating they had, had
problems with them. Not sure if that is what I am going to do yet I know
the throttle body needs cleaned too and will give that a try. What is
the stock plug for my 360?
Think that's it. By the way 99 R/T is what I am working on.
Thanks In advance.
Paul Gottes
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:02:49 EDT