If it's the same as my 2001 QC, you first remove the dust
pan underneath, held in by 4 or 5 quick pop-out connectors.
Then remove the (2) 17mm hex heads on each side, on the
outer sides of the frame. Disconnect the fog lights while
you under there, if your Dak has them. On top of the bumper
bracket there are (2) bolts on both sides, 10mm hex heads, I
think. Off it comes!
Couldn't believe how light the bumper was, doubt it would
survive the 5 m.p.h. crash tests! :-)
Dwight in WI
01 QC V-6, 3:55 LS, Patriot Blue,
9200 miles, Hmbw K&N air, Mobil One,
Spray-in BedLiner, SportsMaster Tonneau,
Yaesu FT-900 and Hmbw ScrewDriver Ant.
----- Original Message -----
From: "Josh Hancock" <jhancock@tcia.net>
To: <dakota-truck@BUFFNET.NET>
Sent: Thursday, September 27, 2001 16:08 PM
Subject: DML:Front Bumper
> Can someone tell me the best way to remove the
> front bumper off my 2000 dak. I'm trying to get it
> ready to be painted and I'm afraid I'll end up doing
> more work then I should since I've never had it off.
> Thanks
> Josh
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:00 EDT