I dunno... I'm sending it back to him tomorrow to see whats going on.
Hopefully its something simple :-)
Doug Myers
-------------
'99 Dakota RC/SB 5.9L/5-speed/3.92SG
K&N Gen II FIPK, Comp Cams '604 cam, Progear timing chain, MP 2-bbl MPI
intake, MP R/T heads, MP polished aluminum valve covers, Hughes' roller
rockers, MP Headers, 3" Dynomax hi-flow cat, 3" Flowmaster, Flowkooler water
pump, Accel Supercoil, MP Plug Wires, Melling HV oil pump, Mike Leach PCM,
Centerforce Dual Friction Clutch
""Bernd D. Ratsch"" <bernd@texas.net> wrote in message
news:000101c14a78$5ffe3230$040aa8c0@homenet.com...
>
> Did someone forget to add a corrected value on the PCM reflash?
>
> ---------------------------
>
> P-0601 Internal Controller Failure
>
> SYMPTOM
> P-0601 INTERNAL CONTROLLER FAILURE
>
> WHEN MONITORED
> With the Ignition Key on
>
> SET CONDITION
> Internal checksum for software failed, does not match calculated value.
>
> POSSIBLE CAUSES
> Internal controller failure
>
> ----------------------------
>
>
> -----Original Message-----
> From: owner-dakota-truck@BUFFNET.NET
> [mailto:owner-dakota-truck@BUFFNET.NET] On Behalf Of Doug Myers
> Sent: Monday, October 01, 2001 7:41 AM
> To: dakota-truck-moderator@bent.twistedbits.net
> Subject: DML: CHECK ENGINE CODE P 0601
>
>
> Hi,
>
> I've had my PCM back from Mike Leach since thurs of last week. The
> problem is I've got a P 0601 error, which is a PCM failure code. What's
> odd is that the truck runs fine, and every function the PCM is supposed
> to do, its doing. Any ideas?
>
> Doug Myers
> -------------
> '99 Dakota RC/SB 5.9L/5-speed/3.92SG
> K&N Gen II FIPK, Comp Cams '604 cam, Progear timing chain, MP 2-bbl MPI
> intake, MP R/T heads, MP polished aluminum valve covers, Hughes' roller
> rockers, MP Headers, 3" Dynomax hi-flow cat, 3" Flowmaster, Flowkooler
> water pump, Accel Supercoil, MP Plug Wires, Melling HV oil pump, Mike
> Leach PCM, Centerforce Dual Friction Clutch
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:09 EDT