The motor mounts on the later vehicles are a fail-safe type. Even if they
fail, the motor can't flop around.
The factory pieces are tough. My 98 5.2 has 65K+ and about 150-200 4000+
rpm launches with slicks!!
The original mounts are STILL in place.
TonyC
-----Original Message-----
From: Aaron Gasparich <acg302@ptd.net>
To: dakota-truck-moderator@bent.twistedbits.net
<dakota-truck-moderator@bent.twistedbits.net>
Date: Tuesday, October 09, 2001 9:45 PM
Subject: DML: engine mounts
>Does anybody out there know where i can get GOOD engine mounts that i dont
>have to replace every 3 months. Preferably polyeuethane. I'm puttin this
318
>in, and i have problem with beakin them with the 6. a tourqe plate or
>cable/chain would be good, but i can figure out where to bolt them on to i
>might just end up machining solid aluminum mounts too.
>-Aaron
>
>
>
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:14 EDT