Hmmm ... two hop grunts equates to about a half a blizz grunt, right?
lmao ... ummm, thanks hop!!!
Kevin DeGarmo
Jackson, MI
http://shakin-notstirred.tripod.com
----Original Message Follows----
From: "hop" <hopsdak@hotmail.com>
Reply-To: dakota-truck@buffnet.net
To: <dakota-truck@buffnet.net>
Subject: DML: Re: Header bolt torque? Revisited
Date: Fri, 30 Nov 2001 20:47:08 -0600
Hey Blizz..
Two Grunts should get it..
hahahaha ROTFLMAO!! ;)
Hop...
----- Original Message -----
From: "Kevin DeGarmo" <blizzzzard69@hotmail.com>
To: <dakota-truck@buffnet.net>
Sent: Friday, November 30, 2001 8:25 PM
Subject: DML: Header bolt torque? Revisited
> Okay, now I realize this question has probably been asked a zillion times
> before, but after searching the archives a bit I couldn't come up with a
> definitive answer.
>
> My JBA header bolts are overdue for a re-torque. I've read anywhere from
> 20-30 lbs to "as tight as you can get 'em" ... JBA instructions say "to
> manufacturer's specs" (whatever that is). I've also read it's almost
> impossible to get a torque wrench on those buggers.
>
> Can anyone tell me (if I can even get the damn wrench on) what I should
> torque those bolts to?
>
> Thanks in advance for any help!!
>
> Kevin DeGarmo
> Jackson, MI
> http://shakin-notstirred.tripod.com
>
> _________________________________________________________________
> Get your FREE download of MSN Explorer at
http://explorer.msn.com/intl.asp
>
>
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com/intl.asp
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:03:37 EDT