Oops...almost forgot:
Electronic Governor Control - You MUST install the resistor if you went
more than 2 turns out on the PR valve. You MUST solder the connections
and use a good shrink wrap to keep it clean. Do not use crimp
connectors...solder and shrinkwrap.
- Bernd
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of Bernd D.
Ratsch
Sent: Sunday, March 17, 2002 8:17 AM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: trans-go?
No check engine light. (Use it if required.)
- Bernd
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net] On Behalf Of TonyC
Sent: Sunday, March 17, 2002 6:07 AM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: trans-go?
Thanks Bernd. Any benefit to just the resistor install?
TonyC
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:10 EDT