Re: RR stud install question

From: jon@dakota-truck.net
Date: Sat Jun 29 2002 - 18:25:17 EDT

Next message: SEMIHEMI01@aol.com: "Test. for AOL"
Previous message: jon@dakota-truck.net: "Re: Spare seats at BBQ?"
In reply to: TonyC: "RR stud install question"
Next in thread: greg conner: "Re: RR stud install question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

"TonyC" <acellan1@tampabay.rr.com> wrote:

: Just how have you guys torqued the studs for the MP RRs which have a round
: base?

I'm not familiar with the MP RRs, but I believe the generally accepted
method of torquing down a stud is to put two nuts on it, tighten them
against each other, then put the torque wrench on the top nut. Once
its in, just loosen the nuts (being careful to only put pressure on the
nuts themself, don't let the wrench loosening the top nut back out the stud
itself) and remove them.

-Jon-

.---- Jon Steiger ------ jon@dakota-truck.net or jon@jonsteiger.com -----. | I'm the: AOPA, DoD, EAA, NMA, NRA, SPA, USUA. Rec & UL Pilot - SEL | | '70 Barracuda, '92 Ram 4x4, '96 Dakota, '96 Intruder 1400, '96 FireFly | `----------------------------------------- http://www.jonsteiger.com ----'

Next message: SEMIHEMI01@aol.com: "Test. for AOL"
Previous message: jon@dakota-truck.net: "Re: Spare seats at BBQ?"
In reply to: TonyC: "RR stud install question"
Next in thread: greg conner: "Re: RR stud install question"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:04:54 EDT