I use those and have had no problems. You'll have to buy a separate set of
guides as the stock ones that are bolted to the valve covers won't work.
Ron
00 PB SLT QC 4X2 5.9 46RE 3.92 LSD
For modifications see my DML Profile (URL follows)
http://www.twistedbits.net/WWWProfile/dakota/Kw9pV1EkFeOYY
-----Original Message-----
From: owner-dakota-truck@dakota-truck.net
[mailto:owner-dakota-truck@dakota-truck.net]On Behalf Of Bill
Sent: Wednesday, August 07, 2002 1:34 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Spark Plug Rewire
I was looking at getting MSD 8.5mm Super Conductor Wire set for my
truck. The replacement part number as best I can find is PN32189. The
question I have is, has anybody installed these? I was looking at the
TSB that addresses re-routing the wires, it looks like they are using
the stock wires, because some of the lengths look too short and go over
the valve cover. If I get the PN32189 set from MSD, is it going to be
the same? I want to get wire loom separators like the ones from "Made
For You Products" has anyone used these? If I do use them would I have
to cut custom length wires to make it look neat?
If anyone has done this and has pictures to share, point me to them or
email me directly with them.
Thanks,
"Bill Nissley" <bill@nissley.com>
'98 CC SLT 2x4 5.2L V8 AT, White/Dftwd with custom stripes, 3" lift, ORW
pre-runner light bar with PIAA 80Pro XT series lights, 32" BFG M/T's,
Yellow Box Speedo Calib., Flowmaster, Powergate, X-2000 bed cover & K&N
filter
This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:12 EDT