Re: Home made intake

From: Eric Giblock (egiblock@hotmail.com)
Date: Tue Aug 13 2002 - 23:53:56 EDT

Next message: Bernd D. Ratsch: "RE: RE: MAP Connector Part Numbers"
Previous message: Eric Giblock: "Re: Gauges"
In reply to: Michael James Burns: "Home made intake"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

i know the one i used on my truck was the K&N RE-0950

i used this on my 3.9v6 with a 3.5" InnerDiameter Filter...

--
--------------------
Eric Giblock
egiblock@hotmail.com
student / web designer
www.gibsdakota.com
"Michael James Burns" <burnsm@engin.umich.edu> wrote in message
news:Pine.SOL.4.33.0208131825280.8153-100000@blue.engin.umich.edu...
>
> I have the instructions and all the parts needed to make the home made
> intake for the 4.7L, but I need the K&N filter number.  the one that is
> 6x9 with a three inch opening.
>
> Thanks
>
> Mike Burns
> University of Michigan
> Mechanical Engineering
>

Next message: Bernd D. Ratsch: "RE: RE: MAP Connector Part Numbers"
Previous message: Eric Giblock: "Re: Gauges"
In reply to: Michael James Burns: "Home made intake"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Jun 20 2003 - 12:05:14 EDT