RE: Cam swap break in?

• Next message: Rick Barnes: "RE: Turn Signal Problem"
• Previous message: fawcett@uism.bu.edu: "Turn Signal Problem"
• Maybe in reply to: Bob Tom: "Cam swap break in?"
• Next in thread: Sam: "RE: RE: Cam swap break in?"
• Reply: Sam: "RE: RE: Cam swap break in?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

Hi Bob,
Once you get it cranked up, run the rpm around 1800rpm for a good 20
minutes. I ran mine between 25-30 minutes on both cam break-ins. After
that, you should be good to go, but I did treat my semi-gently for a few
road miles until I felt comfortable with it.
Have FUN!!!
Rich - Ashburn, VA

-----Original Message-----
From: Bob Tom [mailto:tigers@bserv.com]
Sent: Monday, October 21, 2002 10:04 AM
To: dakota-truck@dakota-truck.net
Subject: DML: Cam swap break in?

Hi to all you cam swappers,

I'd like to know what method you used to break in a roller cam
after the install? Also, what, if any, precautions you took
when driving after the break in? I thank you for any real-life
inputs.

Bob

• Next message: Rick Barnes: "RE: Turn Signal Problem"
• Previous message: fawcett@uism.bu.edu: "Turn Signal Problem"
• Maybe in reply to: Bob Tom: "Cam swap break in?"
• Next in thread: Sam: "RE: RE: Cam swap break in?"
• Reply: Sam: "RE: RE: Cam swap break in?"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
• Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:47:17 EST