RE: Replacing wheel studs

From: Neil W. Bellenger (neil624b@rochester.rr.com)
Date: Mon Dec 16 2002 - 13:11:05 EST

Next message: Chris Orr: "Re: Drink Holders?"
Previous message: Jonathan Lumpkin: "Drink Holders?"
In reply to: blackdak@tampabay.rr.com: "Replacing wheel studs"
Next in thread: Josh Battles: "Re: Replacing wheel studs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

-----Original Message-----
On Behalf Of blackdak@tampabay.rr.com
Subject: DML: Replacing wheel studs

Alex,

That's exactly what the FSM shows. Make sure the stud is started square to
the rotor.
Place three washers on the stud and tighten the nut down with a big wrench
until the flange is seated completely.

Next message: Chris Orr: "Re: Drink Holders?"
Previous message: Jonathan Lumpkin: "Drink Holders?"
In reply to: blackdak@tampabay.rr.com: "Replacing wheel studs"
Next in thread: Josh Battles: "Re: Replacing wheel studs"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:48:14 EST