Yup...sure is.
- Bernd
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of RayB
Sent: Sunday, March 16, 2003 12:06 PM
To: dakota-truck@dakota-truck.net
Subject: RE: DML: Truck won't start when warm....
> -----Original Message-----
> From: owner-dakota-truck@bent.twistedbits.net
> [mailto:owner-dakota-truck@bent.twistedbits.net]On Behalf Of mike
> kulczycki how would i
> check each of those sensors?? or just start replacing... i
> thought about
> paying the $60 or whatever for the diagnostic check and then possibly
> replace the problem myself... i have a fsm for my truck, but it
> says to use
> a drb scanner to check these sensors... i may have to invest in
> one after
> this ordeal is over...
> Mike K
> 94 SLT,CC,239,2wd,auto
> 95 Sport,RC,360,5-speed
Since you have a FSM there should be a section that tells you how to
check the sensors with a volt/ohm meter. That's what I did before
buying an AutoXray scanner.
RayB
http://www.dragtruk.com/ENTRIES/20KM1FD2KWBP.html
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:00 EST