Re: VIPER FAN DIAGRAM.JPG

From: JAMEPC@aol.com
Date: Fri Apr 04 2003 - 12:53:11 EST

I'm installing it on a Gen II. The shroud has to be trimmed slightly but
that's it. It will fit between the pump stud and radiator. The offset fan
has been replaced with the centered one. I have an M1. I removed the gauge
temp sender from the large hole (it had an adaptor to make it fit) and
installed the thermostat there (large threads) and drilled and tapped a small
hole for the gauge temp. sender. Very easy to do. Sorry I'm using "large hole
and small hole", I don't know the exact sizes off hand:)
James

In a message dated 4/4/2003 12:36:37 PM Eastern Standard Time,
barnesrv@attbi.com writes:

> Where on your engine are you going to put that thermostat?
>
>
>
> Rascal
>
>
>
> -----Original Message-----
> From: JAMEPC@aol.com [mailto:JAMEPC@aol.com]
> Sent: Friday, April 04, 2003 12:17 PM
> To: Rich.Wisotzkey@GD-NS.Com; bpracing@worldnet.att.net;
> barnesrv@attbi.com; JBattles@bankfinancial.com
> Subject: Fwd: VIPER FAN DIAGRAM.JPG
>
>
>
> The thermostat I'm going to use is Painless Wireing #PRF30111 185 on/170
> off.
>
>
>

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:10 EST