That did happen yes, the plunger got twisted because i was cleaning it,, is
this a bad thing to do???
joe_himself
>From: "Tony Cellana" <acellan1@tampabay.rr.com>
>Reply-To: dakota-truck@dakota-truck.net
>To: <dakota-truck@dakota-truck.net>
>Subject: DML: Re: Idle Problems, Need Help,
>Date: Sun, 11 May 2003 23:08:57 -0400
>
>
>Did you twist the plunger on the IAC on the back of the TB?
>TonyC
>
>
>-----Original Message-----
>From: Joe Thompson <red97kota@hotmail.com>
>To: dakota-truck@dakota-truck.net <dakota-truck@dakota-truck.net>
>Date: Sunday, May 11, 2003 10:23 PM
>Subject: DML: Idle Problems, Need Help,
>
>
> >
> >
> >ok so today i got bored, got out the dremel tool and started cuttin away
>at
> >my tb,, cut the horns off, made it look a nice and shiney,, brand new
>used,
> >anyways,, go put it back on,, reset computer by turnin key for 30 seconds
> >with - terminal off, put back on,, start up dak,, and what do ya know,,
>its
> >idling at 2300 rpms, then jumps down to about 1800-2000 rpm,. and thats
> >where it stays,, in between there, the dak has ran for almost 30 mins by
>its
> >self, have not touched the gas at all,, Why wont it idle properly,, can
> >anyone help me out???
> >
> >
> >
> >Joe_Himself,
> >
> >_________________________________________________________________
> >MSN 8 with e-mail virus protection service: 2 months FREE*
> >http://join.msn.com/?page=features/virus
> >
> >
>
_________________________________________________________________
MSN 8 helps eliminate e-mail viruses. Get 2 months FREE*.
http://join.msn.com/?page=features/virus
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:19 EST