Don't forget if you grind down the control arm you cannot put the center
caps in the wheels. If you run spacers you need to either get slightly
longer studs or bulge lugnuts like you have with an extension or shank
that extends from the end to grab the thread that you would normally
lose.
Jeff Durling
-----Original Message-----
From: owner-dakota-truck@bent.twistedbits.net
[mailto:owner-dakota-truck@bent.twistedbits.net] On Behalf Of
Pukeloser@aol.com
Sent: Tuesday, June 03, 2003 3:23 PM
To: dakota-truck@dakota-truck.net
Subject: Re: DML: Backspacing On 17x9 Stock R/T Rims - Help
If you are planning to run stock r/t rims on a 95 2wd you will need a
spacer
(about 1/4") or you'll have to grind down the outer edge of your upper
control
arm.
John S
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:26 EST