Re: Re: Re: Are there parts available for a stroker rebuild?

From: greg conner (dodgeboy93@hotmail.com)
Date: Fri Jun 27 2003 - 09:38:00 EDT


I've spoke with stroker kits.com a few times. the crank is 1900 alone and
will stay that pricey unless they can get someone to form the crank out of a
different material. I love my v6 and its cool surprising the v8's out
there. But when I do build a new motor ya better beleive I'm not gonna use
a 1900 dollar billet crank. the 350 buck cast 4in 360 crank will do me just
fine ;)

Greg Conner
1996 RC
3.9 hybrid

>From: "Aaron Wyse" <awyse@sw.rr.com>
>Reply-To: dakota-truck@dakota-truck.net
>To: <dakota-truck@dakota-truck.net>
>Subject: DML: Re: Re: Are there parts available for a stroker rebuild?
>Date: Sat, 28 Jun 2003 07:40:36 -0500
>
>
>Chrysler shows same part numbers for 5.2 & 3.9 internals
>same thing with most 5.9 & 8.0 motors.
>
>I thought mopar had a stroker crank available for the 3.9 at one time, but
>if not, I'd check the prices of the rods and pistons from elsewhere and see
>how much strokerkits wants for just the crank; see if it's cheaper to ,make
>the kit yourself, or if they're giving yuo a decent deal by ordering all
>the
>parts from them.
>Aaron Wyse
>1994 RC WS 2.5L 5spd
>
>----- Original Message -----
>From: "Kyle Vanditmars" <kylevan@telus.net>
>To: <dakota-truck-moderator@bent.twistedbits.net>
>Sent: Thursday, June 26, 2003 11:06 PM
>Subject: DML: Re: Are there parts available for a stroker rebuild?
>
>
> >
> > ""RWP"" <randpark@-no-spam-pacbell.net> wrote in message
> > news:bdgacq$3j8$1@bent.twistedbits.net...
> > >
> > >
> > > Question 1: Are there parts are available for a stroker rebuild of a
>stock
> > > 3.9L Magnum V-6?
> >
> > As Mike said, strokerkits.com has 'em. They are (to put it in the
> > vernacular,) BIG BLING. It would be cool to have a 4.9L V6, though.
> >
> > > Question 2: Can it be done with existing stock parts from other Dodge
> > > Engines?
> >
> > You could theoretically use 318 pistons since it's the same engine with
>a
> > couple bores lopped off... although probably not, as the skirt might
>have
>to
> > be different. The kit that Mike listed is very complete, it has the
>billet
> > crank, H-beam rods, .030" (I think) Forged pistons, rings, and all
>bearings.
> >
> >
> >
>

_________________________________________________________________
Tired of spam? Get advanced junk mail protection with MSN 8.
http://join.msn.com/?page=features/junkmail



This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:31 EST