Re: Gen III wheels on a Gen II

From: Pukeloser@aol.com
Date: Thu Jul 24 2003 - 16:06:01 EDT

Next message: Pukeloser@aol.com: "Air/fuel gauge question"
Previous message: Pukeloser@aol.com: "Re: question on holley fuel pump 12-922"
Maybe in reply to: Quintin: "Gen III wheels on a Gen II"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

Depends on the wheel, the rear will work fine. The front will require either
spacers (1/4") or you'll have to grind down the control arm a bit (this is
wehat I did with my R/T rims) the 16" may be more of a problem because they will
be closeer into the control arm.

John S

Next message: Pukeloser@aol.com: "Air/fuel gauge question"
Previous message: Pukeloser@aol.com: "Re: question on holley fuel pump 12-922"
Maybe in reply to: Quintin: "Gen III wheels on a Gen II"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]
Mail actions: [ respond to this message ] [ mail a new topic ]

This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:39 EST