From: "Steve Mills" <
> The check engine light will not always
> illuminate if you have any codes stored. To check for codes, cycle the
> ignition 3 times and leave it on with 3rd cycle, the check engine light
will
> blink for first digit of first code, pause for bit and blink for second
> digit, then a longer pause before beginning 2nd code. This procedure will
> allways end with a code 55 meaning end of test.
Just lurking on this thread, but for shits and giggles, I tried the above
procedure and the engine light flashed three times .... paused ... flashed
three times again ... paused ... then flashed the ending 55 code.
So I have a code "33". What do I do now? Is there a code reading chart
anywhere on-line? I couldn't find on in the faq's.
Nova Scotia Mike
My Dakota is a 1988 SE 3.9 V6 ...
This archive was generated by hypermail 2b29 : Fri Feb 06 2004 - 11:46:45 EST